Through this period of understanding, I believe that everyone is no stranger to the strong belt buckle , but for customers who want to know more about this product, these contents are not enough. Today, Xiaobian will share the knowledge about the feeding position of the strong belt buckle with everyone, hoping to attract everyone's attention and let everyone have a deep understanding of the strong belt buckle. In this way, everyone can be sure when buying and using a strong belt buckle. The feeding position of the strong belt buckle should conform to the wind direction of the adhesive tape. In order to reduce the impact on the adhesive tape when the material falls, the chute should be used to reduce the material falling gap. The receiving section of the adhesive tape should shorten the gap between the idler rollers and the lining wear-resistant ceramic pipe. The buffer idler is a dyke leakage. The belt side should be referenced with a soft and appropriate amount of baffle plates to prevent the baffle plates from being too hard and scratching the belt buckle. The strength belt buckle should be kept clean during handling and storage to avoid sunlight. Direct sunlight or rain and snow, the dike is in contact with acids and alkali oils, organic solvents and other objects, except for a fever installation of 1 meter. The type, structure, and number of strength belt buckles should be reasonably selected according to the premise of use. The temperature in the cargo compartment during storage should be appropriate. Keep it at -18-40 degrees, and the relative humidity should be kept at 50-80%. The running speed of the conveying tape should not be greater than 2.5 meters / second, and the materials with large block and abrasion should be installed with fixed force discharge. Try to quote low speed.